D-Link DGS-1210/ME series User Manual

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
278
33
MAC-BASED ACCESS CONTROL COMMANDS
The MAC-Based Access Control commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable
mac_based_access_control
disable
mac_based_access_control
config
mac_based_access_control
password
<passwd 16>
config
mac_based_access_control
method
[local | radius]
config
mac_based_access_control port
[<portlist> | all] {state [enable | disable] | aging_time [infinite | <value
1-1440>] | block_time <value 0-300>}
config
mac_based_access_control trap
state
[enable | disable]
config
mac_based_access_control log
state
[enable | disable]
config
mac_based_access_control
max_users
<value 1-1000>
create
mac_based_access_control_local
mac_address
<mac_addr> vlanid <int 1-4094>
show mac_based_access_control {port [<portlist> | all]}
show
mac_based_access_control_local
{mac_address <mac_addr> | vlanid <int 1-4094>}
show
mac_based_access_control_local
auth_state ports
[<portlist> | all]
delete
mac_based_access_control_local
mac_address
<mac_addr> vlanid <int 1-4094>
Each command is listed in detail, as follows:

D-Link DGS-1210/ME series Specifications

General

Layer	Layer 2
MAC Address Table Size	8K
Power Input	100-240 VAC, 50/60 Hz
Certifications	CE, FCC, RoHS
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Port Type	10/100/1000BASE-T
Uplink Ports	SFP ports
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C