DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
18
Parameters None.
Restrictions None.
Example usage:
To display the serial port settings:
DGS-1210-28MP/ME:5# show serial_port
Command: show serial_port
Baud Rate : 9600
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 minutes
DGS-1210-28MP/ME:5#
config serial_port
Purpose
Used to configure the serial port.
Syntax
config serial_port {
baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
Description
The config serial_port command is
used to configure the serial
port’s baud rate and auto logout settings.
Parameters
baud_rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that
will be used to communicate with the management host. There are
four options: 960
0, 19200, 38400 and 115200. Factory default
setting is 115200.
never − No time limit on the length of time the console can be open
with no user input.
2_minutes − The console will log out the current user if there is no
user input for 2 minutes.
5_minutes − The console will log out the current user if there is no
user input for 5 minutes.
10_minutes − The console will log out the current user if there is no
user input for 10 minutes.
15_minutes − The console will log out the current user if there is no
user input for 15 minutes.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the serial port baud rate:
DGS-1210-28MP/ME:5# config serial_port baud_rate 115200
Command: config serial_port baud_rate 115200
Please change your baud rate to 115200 for new baud rate !!
Success.
DGS-1210-28MP/ME:5#
To Next Page
Loading...
