D-Link DGS-1210/ME series - Show Ethernet_Oam Ports

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
311
Example usage:
To show Ethernet OAM statistics of port 1:
DGS-1210-28MP/ME:5# show ethernet_oam ports 1 statistics
Command: show ethernet_oam ports 1 statistics
Port 1
--------------------------------------------------------------------
Information OAMPDU Tx : 0
Information OAMPDU Rx : 0
Unique Event Notification OAMPDU Tx : 0
Unique Event Notification OAMPDU Rx : 0
Duplicate Event Notification OAMPDU Tx: 0
Duplicate Event Notification OAMPDU Rx: 0
Loopback Control OAMPDU Tx : 0
Loopback Control OAMPDU Rx : 0
Variable Request OAMPDU Tx : 0
Variable Request OAMPDU Rx : 0
Variable Response OAMPDU Tx : 0
Variable Response OAMPDU Rx : 0
Organization Specific OAMPDUs Tx : 0
Organization Specific OAMPDUs Rx : 0
Unsupported OAMPDU Tx : 0
Unsupported OAMPDU Rx : 0
Frames Lost Due To OAM : 0
DGS-1210-28MP/ME:5#
show ethernet_oam ports
Purpose Used to display for Ethernet OAM event log.
Syntax
show ethernet_oam ports [<portlist> | all] event_log {index
<value_list>}
Description
The show ethernet_oam ports command is
used to show ports
Ethernet OAM even
t log information. The Switch can buffer 1000
event logs. The event log is different from sys-log. It provides more
detailed information than sys-log. Each OAM event will be recorded
in both OAM event log and system log.
Parameters
[<portlist> | all] − Specifies a port, a range of ports or all ports to be
displayed.
index <value_list> − Specifies an index range to display.
Restrictions None.
Example usage:
To show port 1 external OAM event:
DGS-1210-28MP/ME:5# show ethernet_oam ports 1 event_log index 1
Command: show ethernet_oam ports 1 event_log index 1
Port 1