DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
318
Command Parameter
ports
show igmp
access_authentication
ports
[<portlist> | all]
enable igmp_snooping
{multicast_vlan | forward_mcrouter_only}
disable igmp_snooping
{multicast_vlan | forward_mcrouter_only}
show igmp_snooping
{vlan <vlan_name 32> | vlanid <vidlist> | multicast_vlan <vlan_name 32> |
multicast_vlan_group <vlan_name 32>}
show igmp_snooping
group
[vlan <vlan_name 32> | vlanid <vidlist>] <ipaddr> {data_driven}
show igmp_snooping
forwarding
{vlan <vlan_name 32> | vlanid <vidlist>}
show igmp_snooping
host
{ports <portlist> | group <ipaddr> | vlan <vlan_name 32> | vlanid <vidlist>}
show igmp_snooping
multicast_vlan
{<vlan_name 32>}
show igmp_snooping
multicast_vlan_group
{<vlan_name 32>}
show igmp_snooping
statistic counter
[vlan_name <string 32> | vlanid <vidlist> | ports <portlist>]
clear igmp_snooping
statistics counter
show router_port {vlan <vlan_name 32> | vlanid <vidlist> | static | dynamic | forbidden}
Each command is listed in detail, as follows:
config igmp_snooping
Purpose To configure IGMP snooping on the Switch.
Syntax
config igmp_snooping [vlan_name <string 32> | vlanid <vidlist>
| all] [host_timeout <sec 130-153025> | router_timeout <sec 60-
600> | fast_leave [enable | disable] | | report_suppression
[enable | disable] | state [enable | disable]]
Description
The config igmp_snooping command configures
on the Switch.
Parameters
vlan_name <string 32> − The name of the VLAN for which IGMP
snooping is to be configured.
vlanid <vidlist> −
The VLAN id for which IGMP snooping is to be
configured.
all −
Specifies all VLAN for which IGMP snooping is to be
configured.
host_timeout <sec 130-153025> − Specifies the maximum amount
of time a host can be a member of a multicast group without the
Switch receiving a host membership report. The default is 260
To Next Page
Loading...
