D-Link DGS-1210/ME series - Show Lldp; Show Lldp Ports

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
468
DGS-1210-28MP/ME:5# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DGS-1210-28MP/ME:5#
show lldp
Purpose
To display the Link Layer Discovery Protocol (LLDP) on the switch.
Syntax
show lldp
Description
The show lldp displays the LLDP configuration on the switch.
Parameters None.
Restrictions None.
Example usage:
To show LLDP settings:
DGS-1210-28MP/ME:5# show lldp
Command: show lldp
LLDP System Information
Chassis Id Subtype : MAC Address
Chassis Id : 00-12-10-28-33-95
System Name :
System Description : DGS-1210-28MP/ME 7.01.B030
System Capabilities : Bridge
LLDP Configurations
LLDP Status : Enable
Message Tx Interval : 30
Message Tx Hold Multiplier: 4
ReInit Delay : 2
Tx Delay : 2
Notification Interval : 5
DGS-1210-28MP/ME:5#
show lldp ports
Purpose
To display the Link Layer Discovery Protocol (LLDP) ports
configuration on the switch.
Syntax
show lldp ports {<portlist>}
Description
The show lldp ports command displays the information regarding
the ports.
Parameters
<portlist> − A port or range of ports to be displayed.
Restrictions None.
Example usage:
To show the information for port 1: