D-Link DGS-1210/ME series - Delete Cos Vlanid_Mapping; Config Cos Tos Value

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
209
CoS VLAN id mapping information between an incoming packet’s
802.1p priority value.
Parameters
<vlanid 1-4094> -
Specifies the mapped vlan id information to be
displayed.
Restrictions None.
Example usage:
To display the CoS VLAN id mapping on the Switch:
DGS-1210-28MP/ME:5# show cos vlanid_mapping
Command: show cos vlanid_mapping
VLAN ID Class
----------------------------------------
100 2
DGS-1210-28MP/ME:5#
delete cos vlanid_mapping
Purpose To delete the mapping between an incoming packet’s 802.1p priority
value.
Syntax
delete cos vlanid_mapping vid <vlanid 1-4094>
Description
The delete cos vlanid_mapping command is used to delete the
mapping between an incoming packet’s 802.1p priority value.
Parameters
<vlanid 1-4094> -
Specifies the mapped vlan id information to be
deleted.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To deleted the CoS VLAN id mapping on the Switch:
DGS-1210-28MP/ME:5# delete cos vlanid_mapping vid 100
Command: delete cos vlanid_mapping vid 100
Success.
DGS-1210-28MP/ME:5#
config cos tos value
Purpose To configure the CoS tos on the Switch.
Syntax
config cos tos value <value 0-7> class <priority_id 0-7>
Description
The config cos tos value command is used to configure the CoS
tos on the Switch.
Parameters
<value 0-7> - Specifies the value of the Switch’s tos queue.
<priority 0-7> - Specifies
the number of the Switch’s hardware
priority queue.
Restrictions Only administrator or operator-level users can issue this command.