D-Link DGS-1210/ME series - Config Mac_Based_Access_Control Trap State; Config Mac_Based_Access_Control Log State

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
281
unauthenticated state.
block_time <value 0-300> – If a host fails to pass the authentication,
the next authentication will not started within block_time unless the
user clears the entry state manually.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure port state:
DGS-1210-28MP/ME:5# config mac_based_access_control port all aging_time 100
Command: config mac_based_access_control port all aging_time 100
Success.
DGS-1210-28MP/ME:5#
config mac_based_access_control trap state
Purpose To enable or disable sending of MAC-based Access Control traps.
Syntax
config mac_based_access_control trap state [enable | disable]
Description
The config mac_based_access_control trap state command is
used to enable or disable sending of MAC-
based Access Control
traps.
Parameters
[enable | disable] - .Specifies to enable or disable trap for MAC-
based Access Control.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To enable trap state of MAC-based Access Control:
DGS-1210-28MP/ME:5# config mac_based_access_control trap state enable
Command: config mac_based_access_control trap state enable
Success.
DGS-1210-28MP/ME:5#
config mac_based_access_control log state
Purpose To enable or disable generating of MAC-based Access Control logs.
Syntax
config mac_based_access_control log state [enable | disable]
Description
The config mac_based_access_control log state command is
used to enable or disable generating of MAC-based Access Control
logs.
Parameters
[enable | disable] - .Specifies to enable or disable generating of
MAC-based Access Control logs
Restrictions Only administrator or operator-level users can issue this command.
Example usage: