D-Link DGS-1210/ME series - Delete Cos Udp_Port_Mapping; Config 802.1 P User_Priority

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
213
500 2
DGS-1210-28MP/ME:5#
delete cos udp_port_mapping
Purpose To delete the CoS UDP port mapping information on the Switch.
Syntax
delete cos udp_port_mapping destination_port <value 0-65535>
Description
The delete udp tcp_port_mapping command is used to delete the
CoS TCP port mapping information on the Switch.
Parameters
<value 0-65535> - Specifies the mapped udp port information to be
deleted.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To delete the CoS UDP port mapping on the Switch:
DGS-1210-28MP/ME:5# delete cos udp_port_mapping destination_port 500
Command: delete cos udp_port_mapping destination_port 500
Success.
DGS-1210-28MP/ME:5#
config 802.1p user_priority
Purpose To map the 802.1p user priority of an incoming packet to one of the
four hardware classes of service available on the Switch.
Syntax
config 802.1p user_priority <priority 0-7> <class_id 0-7>
Description
The config 802.1p user_priority command configures the way the
Switch maps an incoming packet, based on its 802.1p user priority
tag, to one of the four hardware priority classes of service available
on the Switch. The Switch’s default is to map the incoming 802.1p
priority values to the four hardware classes of service according to
the following chart:
802.1p value Switch Priority Queue Switch Priority Queue(stack)
------------------ ----------------------------- -------------------------------------
0 1 0
1 0 0
2 0 0
3 1 0
4 2 1
5 2 1
6 3 2
7 3 2
Parameters
<priority 0-7> − The 802.1p priority value (0 to 7) to map to one of
the Switch’s four hardware priority classes of service.
<class_id 0-7> − The Switch’s hardware priority class of service (0