D-Link DGS-1210/ME series - Show 802.1 P User_Priority; Config 802.1 P Default_Priority

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
214
to 7) to map to the 802.1p priority value specified above.
Restrictions Only administrator or operator level users can issue this command.
Example usage:
To configure 802.1 user priorityon the Switch:
DGS-1210-28MP/ME:5# config 802.1p user_priority 2 0
Command: config 802.1p user_priority 2 0
Success.
DGS-1210-28MP/ME:5#
show 802.1p user_priority
Purpose To
display the current mapping between an incoming packet’s
802.1p priority value and one of the Switch’s eight hardware priority
classes of service.
Syntax
show 802.1p user_priority
Description
The show 802.1p user_priority
command displays the current
mapping of an incoming packet’s 802.1p priority value to one of the
Switch’s four hardware priority queues.
Parameters None.
Restrictions None.
Example usage:
To show 802.1p user priority:
DGS-1210-28MP/ME:5# show 802.1p user_priority
Command: show 802.1p user_priority
QOS Class of Traffic
Priority-0 -> <Class-1>
Priority-1 -> <Class-2>
Priority-2 -> <Class-1>
Priority-3 -> <Class-3>
Priority-4 -> <Class-4>
Priority-5 -> <Class-5>
Priority-6 -> <Class-6>
Priority-7 -> <Class-7>
DGS-1210-28MP/ME:5#
config 802.1p default_priority
Purpose To assign an 802.1p priority tag to an incoming untagged packet that
has no 802.1p priority tag.
Syntax
config 802.1p default_priority [<portlist> | all] <priority 0-7>
Description
The config 802.1p default_priority command specifies the 802.1p