D-Link DGS-1210/ME series - Create Snmp Community

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
92
View Name Subtree OID OID Mask View Type
------------ ---------------------- ---------------------- ---------
dlink 1.2.3.4 1.1.1.1 Excluded
ReadWrite 1 1 Included
Total Entries: 2
DGS-1210-28MP/ME:5#
create snmp community
Purpose To
create an SNMP community string to define the relationship
between the SNMP manager and an SNMP agent.
Syntax
create snmp community <community_string 32> [<username
32> | view <view_name 32>] [read_only | read_write]
Description
The create snmp community command creates
an SNMP
community string and assigns access-limiting characteristics to this
community string.
The community string acts like a password to
permit access to the agent on the Switch. One or more of the
following characteristics can be associated with the community
string:
An Access List of IP addresses of SNMP manager
s that are
permitted to use the community string to gain access to the Switch’s
SNMP agent.
A MIB view that defines the subset of all MIB objects to be
accessible to the SNMP community.
Read/write or read-
only level permission for the MIB objects
accessible to the SNMP community.
Parameters
<community_string 32> − A string of up to 32 alphanumeric
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
<username 32> − A string of up to 32 alphanumeric characters that
is used to identify the group of MIB objects that a remote SNMP
manager is allowed to access on the Switch.
<view_name 32> − A string of up to 32 alphanumeric characters that
is used to identify the view name.
[read_only | read_write] – Allow the above community string user to
have read-only or read-
write access to the switch’s SNMP agent.
The default is read-only.
Restrictions Only administrator, operate or power user-level users can issue this
command.
Example usage:
To create the SNMP community string ‘dlink:’
DGS-1210-28MP/ME:5# create snmp community dlink view dlink read_only
Command: create snmp community dlink view dlink read_only
Success.
DGS-1210-28MP/ME:5#