D-Link DGS-1210/ME series - Delete Dot1 V_Protocol_Group; Show Dot1 V_Protocol_Group

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
267
a pre-defined protocol type or a user specified protocol type.
Parameters
group_id <id 1-6> − The ID of protocol group which is used to
identify a set of protocols.
group_name <name 32> − The name of the protocol group. The
maximum length is 32 chars.
<hex 0x0-0xffff> − The protoocl vlaue is used to identify a protocol of
the frame type specified Depending on the frame type, the octet
string will have one of the following values: The form of the input is
0x0 to 0xffff.
Restrictions
Only Administrator and Operator and Power-User-level users can
issue this command.
Example usage:
To add a protocol IPv6 to protocol group 1:
DGS-1210-28MP/ME:5# config dot1v_protocol_group group_id 1 add protocol ethernet_2
0x86DD
Command: config dot1v_protocol_group group_id 1 add protocol ethernet_2
0x86DD
Success.
DGS-1210-28MP/ME:5#
delete dot1v_protocol_group
Purpose To delete a protocol group.
Syntax
delete dot1v_protocol_group [group_id <id 1-16> | group_name
<name 32> | all]
Description
The delete dot1v_protocol_group
command deletes a protocol
group.
Parameters
group_id <id 1-16> − Specifies the group ID to be deleted.
group_name <name 32> − The n
ame of the protocol group. The
maximum length is 32 characters.
Restrictions
Only Administrator and Operator and Power-User-level users can
issue this command.
Example usage:
To delete a protocol group 1:
DGS-1210-28MP/ME:5# delete dot1v_protocol_group all
Command: delete dot1v_protocol_group all
Success.
DGS-1210-28MP/ME:5#
show dot1v_protocol_group
Purpose To display the protocols defined in a protocol group.
Syntax
show dot1v_protocol_group {group_id <id 1-16> | group_name
<name 32>}
Description
The show dot1v_protocol_group command displays the protocols
defined in protocol groups.
Parameters
group_id <id 1-16> − Specifies the group ID to be displayed.