D-Link DGS-1210/ME series - Config Igmp Access_Authentication Ports; Show Igmp Access_Authentication Ports

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
328
DGS-1210-28MP/ME:5#
config igmp access_authentication ports
Purpose To configure the IGMP access authentication on the Switch.
Syntax
config igmp access_authentication ports [<portlist> | all] state
[enable | disable]
Description
The config igmp access_authentication ports command
configures the IGMP access authentication on the Switch.
Parameters
<portlist> − A port or range of ports that will be configured as IGMP
access authentication ports.
all −
Specify all ports to be configured as IGMP access
authentication ports.
state [enable | disable] −
Specifies the state for the port to be
disabled or enabled.
Restrictions Only administrator, operator or power user-level users can issue this
command.
Example usage:
To configure authentication port of IGMP:
DGS-1210-28MP/ME:5# config igmp access_authentication ports all state enable
Command: config igmp access_authentication ports all state enable
Success.
DGS-1210-28MP/ME:5#
show igmp access_authentication ports
Purpose To
display the IGMP access authentication configuration on the
Switch.
Syntax
show igmp access_authentication ports [<portlist> | all]
Description
The show igmp access_authentication
command displays the
IGMP access authentication configuration on the Switch.
Parameters
all − Specifies all ports to be displayed.
<portlist> − A port or range of ports to be displayed on the Switch.
Restrictions Only administrator, operator or power user-level users can issue this
command.
Example usage:
To display the IGMP access authentication:
DGS-1210-28MP/ME:5# show igmp access_authentication ports 1-5
Command: show igmp access_authentication ports 1-5
Port Authentication State
------ -----------------------------------
1 Disabled
2 Disabled
3 Disabled