D-Link DGS-1210/ME series - Show Flood_Fdb; Clear Flood_Fdb

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
187
Description
The config flood_fdb command configures dyn
amically learned
entries from the Switch’s forwarding database.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure FDB dynamic entries:
DGS-1210-28MP/ME:5# config flood_fdb trap disable log enable
Command: config flood_fdb trap disable log enable
Success.
DGS-1210-28MP/ME:5#
show flood_fdb
Purpose To display the Switch’s forwarding database on the Switch.
Syntax
show flood_fdb
Description
The show flood_fdb command displays dynamically learned entries
from the Switch’s forwarding database.
Parameters None.
Restrictions None.
Example usage:
To display FDB dynamic entries:
DGS-1210-28MP/ME:5# show flood_fdb
Command: show flood_fdb
Flooding FDB State : Enabled
Log State : Disabled
Trap State : Disabled
Value VLAN ID MAC Address Time stamp
--------- ------------ ------------------- ------------------
DGS-1210-28MP/ME:5#
clear flood_fdb
Purpose To clear the Switch’s forwarding database of all dynamically learned
MAC addresses.
Syntax
clear flood_fdb
Description
The clear flood_fdb command clears
dynamically learned entries
from the Switch’s forwarding database.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To clear all FDB dynamic entries: