DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
425
DGS-1210-28MP/ME:5# disable command logging
Command: disable command logging
Success.
DGS-1210-28MP/ME:5#
show command logging
Purpose To display the switch’s general command logging configuration
status.
Syntax
show command logging
Description
The show command logging command is used to show the
command logging configuration status.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To show the command logging configuration status:
DGS-1210-28MP/ME:5# show command logging
Command: show command logging
Command Logging State : Enabled
DGS-1210-28MP/ME:5#
To Next Page
Loading...
