D-Link DGS-1210/ME series - Config Cos Udp_Port_Mapping; Show Cos Udp _Port_Mapping

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
212
DGS-1210-28MP/ME:5# delete cos tcp_port_mapping destination_port 500
Command: delete cos tcp_port_mapping destination_port 500
Success.
DGS-1210-28MP/ME:5#
config cos udp_port_mapping
Purpose To configure the CoS UDP port mapping on the Switch.
Syntax
config cos udp_port_mapping destination_port <value 0-65535>
class <class_id 0-7>
Description
The config cos udp _port_mapping command is used to configure
the CoS UDP port mapping on the Switch.
Parameters
<value 0-65535> - Specifies the udp port number to be mapped.
<class_id 0-7> - Specifies
the number of the Switch’s hardware
priority queue.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To configure the CoS UDP port mapping on the Switch:
DGS-1210-28MP/ME:5# config cos udp_port_mapping Ddestination_port 500 class 2
Command: config cos udp_port_mapping destination_port 500 class 2
Success.
DGS-1210-28MP/ME:5#
show cos udp _port_mapping
Purpose To displays the CoS UDP port mapping information on the Switch.
Syntax
show cos udp_port_mapping {destination_port <value 0-
65535>}
Description
The show cos udp _port_mapping command is used to display
the CoS UDP port mapping information on the Switch.
Parameters
<value 0-65535> - Specifies the mapped udp port information to be
displayed.
Restrictions None.
Example usage:
To display the CoS UDP port mapping on the Switch:
DGS-1210-28MP/ME:5# show cos udp_port_mapping
Command: show cos udp_port_mapping
UDP Port Class
-------------------------------------------