DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
242
DGS-1210-28MP/ME:5#
config erps raps_vlan tc_propagation
Purpose Used to configure the state of the topology change propagation for
the sub-ring.
Syntax
config erps raps_vlan <vlanid 1-4094> sub_ring raps_vlan
<vlanid 1-4094> tc_propagation state [enable | disable]
Description
The config erps raps_vlan tc_propagation command is
configure the state of the topology change propagation for the sub-
ring default instance. This command is applied on the
interconnection node.
Parameters
<vlanid 1-4094> - Specifies the R-APS VLAN id to be configured.
sub_ring raps_vlan <vlanid 1-4094> - Specifies the sub-ring R-APS
VLAN to be configured.
state [enable | disable] –
Specified to enable or disable the
propagation state of the topology change for the sub-ring The default
value is disabled.
Restrictions Only Administrator, operator and power user-level users can issue
this command.
Example usage:
To enable topology change propagation on R-APS VLAN 4094 for sub-ring 2:
DGS-1210-28MP/ME:5# config erps raps_vlan 4094 sub_ring raps_vlan 2
tc_propagation state enable
Command: config erps raps_vlan 4094 sub_ring raps_vlan 2 tc_propagation state
enable
Success.
DGS-1210-28MP/ME:5#
config erps raps_vlan revertive
Purpose Used to configure the revertive mode.
Syntax
config erps raps_vlan <vlanid 1-4094> revertive [enable |
disable]
Description
The config erps raps_vlan revertive command is used to configure
the revertive mode for specified ring’s default instance. When
revertive is enabled, the traffic link is restored to the working
transport link. When revertive is disabled, the traffic link is allowed to
use the RPL, after recovering from a failure.
Parameters
<vlanid 1-4094> - Specifies the R-APS VLAN id to be configured.
revertive [enable | disable] – Specified to enable or disable revertive.
The default value is enabled.
To Next Page
Loading...
