D-Link DGS-1210/ME series User Manual

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
393
clear arptable
Purpose To remove all dynamic ARP table entries.
Syntax
clear arptable
Description
The clear arptable command is used to remove dynamic ARP table
entries from the Switch’s ARP table. Static ARP table entries are not
affected.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To remove dynamic entries in the ARP table:
DGS-1210-28MP/ME:5# clear arptable
Command: clear arptable
Success.
DGS-1210-28MP/ME:5#
create arpentry
Purpose To create an entry for ARP table on the Switch.
Syntax
create arpentry <ipaddr> <macaddr>
Description
The create arpentry <ipaddr> <macaddr> command is used to
create an entry for ARP table on the Switch.
Parameters
<ipaddr> – Specify the IP address to be configured.
<macaddr> – Specify the MAC address to be configured.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To create an ARP entry:
DGS-1210-28MP/ME:5# create arpentry 10.90.90.94 00-00-00-01-02-03
Command: create arpentry 10.90.90.94 00-00-00-01-02-03
Success.
DGS-1210-28MP/ME:5#

D-Link DGS-1210/ME series Specifications

General

Layer	Layer 2
MAC Address Table Size	8K
Power Input	100-240 VAC, 50/60 Hz
Certifications	CE, FCC, RoHS
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Port Type	10/100/1000BASE-T
Uplink Ports	SFP ports
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C