D-Link DGS-1210/ME series - Enable Gratuitous_Arp Log; Disable Gratuitous_Arp Log

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
145
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable learning of ARP entries based on the received gratuitous ARP packets:
DGS-1210-28MP/ME:5# config gratuitous_arp learning enable
Command: config gratuitous_arp learning enable
Success.
DGS-1210-28MP/ME:5#
enable gratuitous_arp log
Purpose Used to enable the gratuitous ARP trap and log.
Syntax enable gratuitous_arp log
Description
The enable gratuitous_arp command is used to enable gratuitous
ARP log states. The Switch can trap or log the IP conflict event to
inform the administrator. By default, the event log is enabled.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable the System’s interface gratuitous ARP log:
DGS-1210-28MP/ME:5# enable gratuitous_arp log
Command: enable gratuitous_arp log
Success.
DGS-1210-28MP/ME:5#
disable gratuitous_arp log
Purpose Used to disable the gratuitous ARP trap and log.
Syntax disable gratuitous_arp log
Description
The disable gratuitous_arp command is used to disable gratuitous
ARP log states. The Switch can trap and log the IP conflict event to
inform the administrator. By default, the event log is enabled.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable the System’s interface gratuitous ARP log:
DGS-1210-28MP/ME:5# disable gratuitous_arp log
Command: disable gratuitous_arp log