D-Link DGS-1210/ME series - Show Erps Instance; Erps Clear Instance

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
255
Success.
DGS-1210-28MP/ME:5#
show erps instance
Purpose Used to display the ERPS instance information on the switch.
Syntax
show erps instance <value 1-16> {sub_ring_instance}
Description
The show erps instance is used to display ERPS instance
information on the switch.
Parameters
<value 1-16> – Specifies the instance ID to be displayed.
{sub_ring_instance} – Specifies the sub-
ring instance to be
displayed.
Restrictions None.
Example usage:
To display the instance 3 of ERP:
DGS-1210-28MP/ME:5# show erps instance 3
Command: show erps instance 3
Instance : 3
Instance Status : Disabled
Instance R-APS VLAN : 0
West : virtual_channel(Forwarding)
East : 0 (Forwarding)
RPL Port : -
RPL Role : None
Protected VLANs :
Instance MEL : 1
Holdoff Time : 0 milli-seconds
Guard Time : 500 milli-seconds
WTR Time : 5 minutes
Revertive Mode : Enabled
Current Instance State : Deactivated
DGS-1210-28MP/ME:5#
erps clear instance
Purpose Used to clear ERPS instance.
Syntax
erps clear instance <value 1-16>
Description
The erps clear instance is used to clear ERPS instance
on the
switch.
Parameters
<value 1-16> – Specifies the instance ID to be cleared.