D-Link DGS-1210/ME series - Enable Dos_Prevention Trap_Log; Disable Dos_Prevention Trap_Log

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
60
Command: show dos_prevention land_attack
DoS Type : Land Attack
State : Enabled
Action : Drop
Frame Counts : -
DGS-1210-28MP/ME:5#
enable dos_prevention trap_log
Purpose Used to enable a DoS prevention trap/log.
Syntax
enable dos_prevention trap_log
Description
The enable dos_prevention trap_log command is used to send
traps and logs when a DoS attack event occurs. The event will be
logged only when the action is specified as drop.
Parameters None.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable a DoS prevention trap/log:
DGS-1210-28MP/ME:5# enable dos_prevention trap_log
Command: enable dos_prevention trap_log
Success.
DGS-1210-28MP/ME:5#
disable dos_prevention trap_log
Purpose Used to disable a DoS prevention trap/log.
Syntax
disable dos_prevention trap_log
Description
The disable dos_prevention trap_log command is used to disable
a DoS prevention trap/log.
Parameters None.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To disable a DoS prevention trap/log:
DGS-1210-28MP/ME:5# disable dos_prevention trap_log
Command: disable dos_prevention trap_log
Success.
DGS-1210-28MP/ME:5#