D-Link DGS-1210/ME series - Energy Efficient Ethernet Commands; Config EEE Port; Show Eee_Mode Port

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
459
61
ENERGY EFFICIENT ETHERNET COMMANDS
The Energy Efficient Ethernet (EEE) commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
config EEE port [all | <portlist>] state [enable | disable]
show EEE_mode {ports <portlist>}
Each command is listed in detail, as follows:
config EEE port
Purpose To enable or disable the EEE function on the specified port(s) on the
Switch.
Syntax
config EEE port [all | <portlist>] state [enable | disable]
Description
The config EEE port command is used to enable or disable the
EEE function on the specified port(s) on the Switch.
Parameters
[all | <portlist> - A range of ports or all ports to be configured.
[enable | diable] – Specifies to enable or disable the EEE function for
the specified ports.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable the EEE function of ports 1-5:
DGS-1210-28MP/ME:5# config EEE port 1-5 state enable
Command: config EEE port 1-5 state enable
Success.
DGS-1210-28MP/ME:5#
show EEE_mode port
Purpose To display the EEE function state on the specified port(s).
Syntax
show EEE_mode {ports <portlist>}
Description
The show EEE_mode port command is used to display the EEE
function state on the specified port(s).
Parameters
<portlist> - A range of ports or all ports to be displayed.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage: