D-Link DGS-1210/ME series - Config Ddp Report State; Config Ddp Report Timer

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
46
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To disable the D-Link discover protocol function:
DGS-1210-28MP/ME:5# disable ddp
Command: disable ddp
Success.
DGS-1210-28MP/ME:5#
config ddp report state
Purpose To enable or disable the D-Link discover protocol packet report
function.
Syntax
config ddp report state [enable | diasble]
Description
The config ddp report state command is used to enable or disable
the D-Link discover protocol packet report function.
Parameters
[enable | disable] – Specifies to enable or disable the D-Link
discover protocol packet report function.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To enable the D-Link discover protocol packet report function:
DGS-1210-28MP/ME:5# config ddp report state enable
Command: config ddp report state enable
Success.
DGS-1210-28MP/ME:5#
config ddp report timer
Purpose To configure the D-Link discover protocol packet report timer.
Syntax
config ddp report timer [30 | 60 | 90 | 120]
Description
The config ddp report timer command is used configure the D-Link
discover protocol packet report timer.
Parameters
[30 | 60 | 90 | 120] - Specifies the report timer of D-Link Discover
Protocol in seconds.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To configure the D-Link discover protocol packet report timer: