D-Link DGS-1210/ME series - Create Igmp_Snooping Multicast_Vlan; Config Igmp_Snooping Multicast_Vlan

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
320
command.
Example usage:
To configure the igmp snooping:
DGS-1210-28MP/ME:5# config igmp_snooping querier vlanid 2 state enable
Command: config igmp_snooping querier vlanid 2 state enable
Success .
DGS-1210-28MP/ME:5#
create igmp_snooping multicast_vlan
Purpose To create an IGMP snooping multicast VLAN on the Switch.
Syntax
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid
2-4094>
Description
The create igmp_snooping multicast_vlan command creates an
IGMP snooping multicast VLAN on the Switch.
Parameters
<vlan_name 32> − The name of the VLAN for which IGMP snooping
is to be created. Up to 32 characters can be used.
<vlanid 2-4094> − The ID of the VLAN for which IGMP snooping is
to be created. The range is from 2 to 4094.
Restrictions Only administrator or operator-level users can issue this command.
Example usage:
To create a igmp snooping multicast VLAN:
DGS-1210-28MP/ME:5# create igmp_snooping multicast_vlan mvln2 5
Command: create igmp_snooping multicast_vlan mvln2 5
Success.
DGS-1210-28MP/ME:5#
config igmp_snooping multicast_vlan
Purpose To configure IGMP snooping multicast VLAN on the Switch.
Syntax
config igmp_snooping multicast_vlan <vlan_name 32> [add |
delete] [member_port <portlist> | source_port <portlist> |
untag_source_port <portlist> | tag_member_port <portlist>]
state [enable | disable] {replace_source_ip [none | <ipaddr>] |
remap_priority [<value 0-7> | none]
source_port_dynamical_learn state [enable | disable] }
Description
The config igmp_snooping multicast_vlan
command enables
IGMP snooping multicast VLAN on the Switch.
Parameters
<vlan_name 32> − The name of the VLAN for which IGMP snooping
is to be configured. Up to 32 characters can be used.
[add | delete] − Add or delete the specified multicast VLAN of IGMP
snooping.
member_port <portlist> − Specifies a port or a range of ports to be