D-Link DGS-1210/ME series - Enable Snmp DHCP_ Screening Traps; Disable Snmp DHCP_ Screening Traps

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
113
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP support on the Switch:
DGS-1210-28MP/ME:5# disable snmp
Command: disable snmp
Success.
DGS-1210-28MP/ME:5#
enable snmp DHCP_ screening traps
Purpose To enable SNMP DHCP screening traps.
Syntax
enable snmp DHCP_screening traps
Description
The enable snmp DHCP_screening traps
command enables
SNMP DHCP screening traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP DHCP screening traps support on the Switch:
DGS-1210-28MP/ME:5# enable snmp DHCP_screening traps
Command: enable snmp DHCP_screening traps
Success.
DGS-1210-28MP/ME:5#
disable snmp DHCP_ screening traps
Purpose To disable SNMP DHCP screening traps.
Syntax
disable snmp DHCP_screening traps
Description
The disable snmp DHCP_screening traps
command enables
SNMP DHCP screening traps support on the Switch.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To disable SNMP DHCP screening traps support on the Switch:
DGS-1210-28MP/ME:5# disable snmp DHCP_screening traps
Command: disable snmp DHCP_screening traps
Success.
DGS-1210-28MP/ME:5#