D-Link DGS-1210/ME series - Disable Dhcp_Local_Relay; Config Dhcp_Local_Relay Port

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
136
To enable the DHCP Local Relay:
DGS-1210-28MP/ME:5# enable dhcp_local_relay
Command: enable dhcp_local_relay
Success.
DGS-1210-28MP/ME:5#
disable dhcp_local_relay
Purpose To disable the DHCP local relay feature globally.
Syntax disable dhcp_local_relay
Description
The disable dhcp_local_relay command
disables the DHCP local
relay feature on the Switch.
Parameters None.
Restrictions Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To disable the DHCP Local Relay:
DGS-1210-28MP/ME:5# disable dhcp_local_relay
Command: disable dhcp_local_relay
Success.
DGS-1210-28MP/ME:5#
config dhcp_local_relay port
Purpose To enable or disable the ports of DHCP Local Relay.
Syntax
config dhcp_local_relay port <portlist> state [enable | disable]
Description
The config dhcp_local_relay port command is used to enable or
disable the ports of DHCP Local Relay.
Parameters
<portlist> – Specifies the ports to be enabled or disabled.
state [enable | disable] – Enable or disable the specified ports of the
DHCP Local Relay status.
Restrictions Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To enable the port 8-10 of DHCP Local Relay:
DGS-1210-28MP/ME:5# config dhcp_local_relay port 8-10 state enable
Command: config dhcp_local_relay port 8-10 state enable