D-Link DGS-1210/ME series - Config Dhcpv6_Relay Option_37; Config Dhcpv6_Relay Option_38

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
141
Success.
DGS-1210-28MP/ME:5#
config dhcpv6_relay option_37
Purpose Used to configure the DHCPv6 relay option 37 of the switch.
Syntax
config dhcpv6_relay
option_37 [check [enable | disable] |
remote_id [cid_with_user_define <string 128> | default |
user_define <string 128>] | state]
Description
The config dhcpv6_relay option_37 command is used to configure
the DHCPv6 relay option 37 of the switch.
Parameters
check [enable | disable] –
Specifies the DHCPv6 Relay Option37
Check to be enabled or disabled.
cid_with_user_define <string 128> –
Specifies the DHCPv6 Relay
Option37 Remote ID type.
user_define <string 128> - Specifies the DHCPv6 Relay Option37
Remote ID type.
Restrictions Only Administrator or operate-level users can issue this command.
Example usage:
To configure the DHCPv6 relay option 37 on the Switch:
DGS-1210-28MP/ME:5# config dhcpv6_relay option_37 remote_id default
Command: config dhcpv6_relay option_37 remote_id default
Success!
DGS-1210-28MP/ME:5#
config dhcpv6_relay option_38
Purpose Used to configure the DHCPv6 relay option 38 of the switch.
Syntax
config dhcpv6_relay option_38 ports <portlist> [state [enable |
disable] | subscriber_id [default | user_define <string 128>]]
Description
The config dhcpv6_relay option_38 command is used to configure
the DHCPv6 relay option 38 of the switch.
Parameters
ports <portlist> - Specifies the ports to be configured.
state [enable | disable] –
Specifies the DHCPv6 Relay Option37
state to be enabled or disabled.
subscriber_id [default | user_define <string 128>] -
Specifies the
subscriber id to use default value or user defined.
Restrictions Only Administrator or operate-level users can issue this command.
Example usage:
To configure the DHCPv6 relay option 38 on the Switch:
DGS-1210-28MP/ME:5# config dhcpv6_relay option_38 ports 3 subscriber_id default