DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
449
Example usage:
To delete a user-defined RADIUS authentication server host:
DGS-1210-28MP/ME:5# delete authen server_host 10.1.1.121 protocol radius
Command: delete authen server_host 10.1.1.121 protocol radius
Success.
DGS-1210-28MP/ME:5#
show authen server_host
Purpose To view a user-defined authentication server host.
Syntax
show authen server_host
Description
The show authen server_host command displays user-defined
authentication server hosts previously created on the Switch.
The following parameters are displayed:
IP Address – The IP address of the authentication server host.
Protocol – The protocol used by the server host. Possible results
include TACACS+ or RADIUS.
Port – The virtual port number on the server host. The default value
is 49.
Timeout - The time in seconds the Switch waits for the server host to
reply to an authentication request.
Retransmit - The value in the retransmit field denotes how many
times the device resends an authentication request when the
TACACS server does not respond. This field is inoperable for the
tacacs+ protocol.
Key - Authentication key to be shared with a configured TACACS+
server only.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To view authenticaion server hosts currently set on the Switch:
To Next Page
Loading...
