D-Link DGS-1210/ME series - Page 185

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
165
Parameters
<integer 3-30> − Specify the system login time.
The range is
between 3 and 30 minutes.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the system login timeout:
DGS-1210-28MP/ME:5# config syslogintimeout 30
Command: config syslogintimeout 30
Success.
DGS-1210-28MP/ME:5#
config sysgroupinterval
Purpose To configure the system group interval to optimal frequency.
Syntax
config sysgroupinterval [<integer 120-1225> | 0]
Description
The config sysgroupinterval command is used to
configure the
system group interval to optimal frequency.
Parameters
[<integer 120-1225> | 0] − Specify the system group interval. And
the range is from 120 to 1225 seconds.
0 means disabling the
reporting function.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the system group interval:
DGS-1210-28MP/ME:5# config sysgroupinterval 200
Command: config sysgroupinterval 200
Success.
DGS-1210-28MP/ME:5#
show log_software_module
Purpose To display the protocols or applications which support the enhanced
logs.
Syntax
show log_software_module
Description
The show log_software_module command is used to display the
protocols or applications that support the enhanced logs.
Parameters None.
Restrictions None.
Example usage:
To display the protocols or applications that supports the enhanced log:
DGS-1210-28MP/ME:5# show log_software_module
Command: show log_software_module
LinkStatus WEB CLI SYSTEM