DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
473
DGS-1210-28MP/ME:5# config lldp ports 2 dot3_tlvs mac_phy_configuration_status
enable
Command: config lldp ports 2 dot3_tlvsmac_phy_configuration_status enable
Success.
Purpose To define LLDP management basic TLVs advertisement on a port or ports.
Syntax
config lldp por
ts [<portli
st>|all
] dot1_tlv_pvid [disabl
e | enable
]
Description
The config lldp ports dot1 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
[enable | disable] - Defines if the advertisement is enabled or disabled.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP TLV PVID:
DGS-1210-28MP/ME:5# config lldp ports all dot1_tlv_pvid disable
Command: config lldp ports all dot1_tlv_pvid disable
Success.
Purpose To define LLDP management basic TLVs advertisement on a port or ports.
Syntax
config lldp por
ts [<portli
st>|all
] dot1_tlv_protocol
_identity
[all | eapol |
gvrp | lacp | stp][disable | enable]
Description
The config lldp ports dot1 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
dot1_tlv_protocol_identity − Defines if the advertisement is enabled or
disabled. The possible values are: eapol, gvrp, lacp, stp or all.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP ports configuration status:
DGS-1210-28MP/ME:5# config lldp ports all dot1_tlv_protocol_identity eapol
enable
Command: config lldp ports all dot1_tlv_protocol_identity eapol enable
Success.
To Next Page
Loading...
