DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
485
• code – Specifies that the Switch examine each frame’s
ICMP code field.
• type – Specifies that the Switch examine each frame’s IGMP
Type field.
tcp – Specifies that the Switch examines each frames protocol
field and its value must be 6 (Transmission Control Protocol-
TCP) for the action to take place.
• src_port_mask <hex 0x0-0xffff> – Specifies the TCP port
mask for the source port.
• dst_port_mask <hex 0x0-0xffff> – Specifies the TCP port
mask for the destination port.
• flag_mask - Specifies the appropriate flag.
udp – Specifies that the Switch examines each frame’s protocol
field and it’s value must be 17 (User Datagram Protocol-UDP) in
order for the action to take place.
• src_port_mask <0x0-0xffff> – Specifies the UDP port mask
for the source port.
• dst_port_mask <0x0-0xffff> – Specifies the UDP port mask
for the destination port mask.
• protocol_id_mask <0x0-0xffff> – Specifies the protocol id
mask.
• source_ip_mask <netmask> – Specifies the source IPv4
mask.
• destination_ip_mask <netmask> – Specifies the destination
IPv4 mask.
dscp – Specifies that the Switch examines the DiffServ Code Point
(DSCP) field in each frame’s header.
ipv6 - Specifies that the Switch examines the IPv6 fields in each
packet with special emphasis on one or more of the following:
• class – Examine the class field of the IPv6 header.
• source_ipv6_mask <ipv6mask> – Specifies the source IPv6
mask.
• destination_ipv6_mask < ipv6mask > – Specifies the
destination IPv6 mask.
profile_id <value 1-3> – Specifies the cpu access profile to be
displayed.
Restrictions Only administrator or operate-level users can issue this command.
Example usage:
To create a CPU IP access profile:
DGS-1210-28MP/ME:5#
create cpu access_profile ip source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type profile_id 2
Command:
create cpu access_profile ip source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type profile_id 2
Success.
DGS-1210-28MP/ME:5#
To Next Page
Loading...
