Enterasys D-Series

Configuring Link Layer Discovery Protocol and LLDP-MED
5-14 Discovery Protocol Configuration
Configuration Tasks
Thecommandsincludedinthisimplementationallowyoutoperformthefollowingconfiguration
tasks:
For information about... Refer to page...
show lldp 5-15
show lldp port status 5-15
show lldp port trap 5-16
show lldp port tx-tlv 5-16
show lldp port location-info 5-17
show lldp port local-info 5-18
show lldp port remote-info 5-20
set lldp tx-interval 5-22
set lldp hold-multiplier 5-22
set lldp trap-interval 5-23
set lldp med-fast-repeat 5-23
set lldp port status 5-24
set lldp port trap 5-24
set lldp port med-trap 5-25
set lldp port tx-tlv 5-25
clear lldp 5-27
clear lldp port status 5-27
clear lldp port trap 5-28
clear lldp port med-trap 5-28
clear lldp port tx-tlv 5-29
Step Task Command(s)
1. Configure global system LLDP parameters set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
2. Enable/disable specific ports to:
• Transmit and process received LLDPDUs
• Send LLDP traps
• Send LLDP-MED traps
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap