Enterasys D-Series

set sntp poll-retry
Enterasys D-Series CLI Reference 14-31
Example
ThisexampleshowshowtocleartheSNTPpollinterval:
D2(su)->clear sntp poll-interval
set sntp poll-retry
UsethiscommandtosetthenumberofpollretriestoaunicastSNTPserver.
Syntax
set sntp poll-retry retry
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthenumberofSNTPpollretriesto5:
D2(su)->set sntp poll-retry 5
clear sntp poll-retry
UsethiscommandtoclearthenumberofpollretriestoaunicastSNTPserver.
Syntax
clear sntp poll-retry
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthenumberofSNTPpollretries:
D2(su)->clear sntp poll-retry
retry Specifiesthenumberofretries.Validvaluesare0to10.