Enterasys D-Series

Configuring SNMP Target Addresses
Enterasys D-Series CLI Reference 7-25
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearSNMPtargetparametersnamed“v1ExampleParams”:
D2(su)->clear snmp targetparams v1ExampleParams
Configuring SNMP Target Addresses
Purpose
ToreviewandconfigureSNMPtargetaddresseswhichwillreceiveSNMPnotificationmessages.
AnaddressconfigurationcanbelinkedtooptionalSNMPtransmit,ortarget,parameters(suchas
timeout,retrycount,andUDPport)setwiththesetsnmptargetparamscommand(page7‐24).
Commands
show snmp targetaddr
UsethiscommandtodisplaySNMPtargetaddressinformation.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
Parameters
Defaults
IftargetAddrisnotspecified,entriesforalltargetaddressnameswillbedisplayed.
targetParams SpecifiesthenameoftheparameterintheSNMPtargetparameterstable
tobecleared.
For information about... Refer to page...
show snmp targetaddr 7-25
set snmp targetaddr 7-26
clear snmp targetaddr 7-28
targetAddr (Optional)Displaysinformationforaspecifictargetaddressname.
volatile|nonvolatile
|read‐only
(Optional)Whentargetaddressisspecified,displaystargetaddress
informationforaspecificstoragetype.