Enterasys D-Series

show system enhancedbuffermode
Enterasys D-Series CLI Reference 2-15
Mode
Switchcommand,read‐only.
Examples
Thisexampleshowshowtodisplaythesystem’sCPU utilization:
D2(ro)->show system utilization cpu
Total CPU Utilization:
Switch CPU 5 sec 1 min 5 min
-----------------------------------------------
1 1 50% 49% 49%
Thisexampleshowshowtodisplaythesystem’soverallmemoryusage:
D2(ro)->show system utilization storage
Storage Utilization:
Type Description Size(Kb) Available (Kb)
---------------------------------------------------------------
RAM RAM device 262144 97173
Flash Images, Config, Other 31095 8094
Thisexampleshowshowtodisplayinformationabouttheprocessesrunningonthesystem.Only
partialoutputisshown.
D2(ro)->show system utilization process
Switch:1 CPU:1
TID Name 5Sec 1Min 5Min
----------------------------------------------------------
c157930 ipMapForwardingTask 3.60% 3.02% 3.48%
cc70000 RMONTask 0.00% 0.00% 0.00%
ccb0b60 SNMPTask 34.80% 34.06% 31.78%
d4847a0 tEmWeb 0.00% 0.03% 0.01%
d4ca360 hapiRxTask 3.20% 4.80% 5.00%
dec8600 lvl7TaskUtilMonitorTas 0.40% 0.40% 0.40%
eb74120 bcmRX 2.00% 2.91% 4.48%
eb7fbc8 bcmLINK.0 0.40% 0.22% 0.32%
f00c9a0 bcmTX 0.00% 0.33% 0.53%
f027648 bcmCNTR.0 0.00% 0.00% 0.03%
f034858 bcmL2X.0 0.00% 0.02% 0.04%
show system enhancedbuffermode
Usethiscommandtodisplaythestatusofenhancedbuffermode,whichoptimizesbuffer
distributionfornon‐stackingsingleCoSqueueoperation.
Syntax
show system enhancedbuffermode
Parameters
None.
Defaults
None.