Enterasys D-Series

set cos state
Enterasys D-Series CLI Reference 11-19
4. IntheCoSsettingstable,configureaCoSsettingforCoSindex1,whichhasapriorityof0.We
entertheIRLreference,createdinthepreviousstep.
D2(su)->set cos settings 0 irl-reference 1
D2(su)->show cos settings
CoS Index Priority ToS IRL
--------- ---------- ------- -----
0 0 * 1
1 1 * *
2 2 * *
3 3 * *
4 4 * *
5 5 * *
6 6 * *
7 7 * *
Commands
set cos state
UsethiscommandtoenableordisableClassofService.
Syntax
set cos state {enable | disable}
For information about... Refer to page...
set cos state 11-19
show cos state 11-20
clear cos state 11-20
set cos settings 11-21
clear cos settings 11-22
show cos settings 11-22
set cos port-config 11-23
show cos port-config 11-24
clear cos port-config 11-25
set cos port-resource 11-26
show cos port-resource 11-27
clear cos port-resource 11-28
set cos reference 11-28
show cos reference 11-29
clear cos reference 11-30
show cos unit 11-31
clear cos all-entries 11-31
show cos port-type 11-32