Enterasys D-Series - Show License; Clear License

show license
3-2 Activating Licensed Features
Usage
Whenyouexecutethesetlicensecommand,youwillbepromptedtoacceptthelicense
agreement.Ifyoudonotaccepttheli censeagreement,thelicensedfeaturewillnotbeenabled.
Example
ThisexampleshowshowtoactivatealicenseonaD‐Seriesswitch.
D2(rw)->set license D2Policy
Terms of this license may be found at
http://www.enterasys.com/support/fla.aspx
Do you accept the terms of the applicable policy license (y/n) [n]?y
License successfully enabled
show license
Usethiscommandtodisplaylicensekeyinformationforswitcheswithactivatedlicenses.
Syntax
show license
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Licensescanbedisplayed,applied,andclearedonlywiththelicens e commandsdescribedinthis
chapter.Generalconfigurationcommandssuchasshowconfigorclearconfigdonotaffect
licenses.
Example
Thisexampleshowshowtodisplaylicensekeyinformation.
D2(ro)->show license
D2Policy: status Active
clear license
Usethiscommandtoclearthelicensesettings.
Syntax
clear license featureId feature