Enterasys D-Series

set pwa maxrequest
Enterasys D-Series CLI Reference 17-71
Defaults
Ifport‐stringisnotspecified,quietperiodwillbesetforallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthePWAquietperiodto30secondsforportsge.1.5‐7:
D2(su)->set pwa quietperiod 30 ge.1.5-7
set pwa maxrequest
Usethiscommandtosetthemaximumnumberoflogonattemptsallowedbeforetransitioning
thePWAporttoaheldstate.
Syntax
set pwa maxrequests requests [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,maximumrequestswillbesetforallports.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthePWAmaximumrequeststo3forallports:
D2(su)->set pwa maxrequests 3
set pwa portcontrol
ThiscommandenablesordisablesPWAauthenticati ononselectports.
Syntax
set pwa portcontrol {enable | disable} [port-string]
maxrequests Specifiesthemaximumnumberoflogonattempts.
port‐string (Optional)Setsthemaximumrequestsforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 6‐1.