Enterasys D-Series User Manual

Factory Default Settings
1-2 Introduction
• RemotelyusingWebView™,EnterasysNetworks’embeddedwebserverapplication.
TheInstallationGuideforyourD‐Seriesdeviceprovidessetup instructionsforconnectinga
terminalormodemtotheswitch.
Factory Default Settings
ThefollowingtableslistfactorydefaultsettingsavailableontheD‐Seriesswitch.
Table 1-1 Default Settings for Basic Switch Operation
Feature Default Setting
Switch Mode Defaults
CDP discovery protocol Auto enabled on all ports.
CDP authentication code Set to 00-00-00-00-00-00-00-00
CDP hold time Set to 180 seconds.
CDP interval Transmit frequency of CDP messages set to 60 seconds.
Cisco discovery protocol Auto enabled on all ports.
Cisco DP hold time Set to 180 seconds.
Cisco DP interval timer Set to 60 seconds.
Community name Public.
Console (serial) port
required settings
Baud rate: 9600
Data bits: 8
Flow control: disabled
Stop bits: 1
Parity: none
DHCP server Disabled.
EAPOL Disabled.
EAPOL authentication
mode
When enabled, set to auto for all ports.
GARP timer Join timer set to 20 centiseconds; leave timer set to 60 centiseconds; leaveall
timer set to 1000 centiseconds.
GVRP Globally enabled.
History buffer size 20 lines.
IEEE 802.1 authentication Disabled.
IGMP snooping Disabled. When enabled, query interval is set to 260 seconds and response
time is set to 10 seconds.
IP mask and gateway Subnet mask set to 0.0.0.0; default gateway set to 0.0.0.0.
IP routes No static routes configured.
Jumbo frame support Enabled on all ports.
Link aggregation control
protocol (LACP)
Enabled.
Link aggregation admin
key
Set to 32768 for all ports.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English