Enterasys D-Series

show snmp persistmode
Enterasys D-Series CLI Reference 2-35
Commands
show snmp persistmode
Usethiscommandtodisplaytheconfigurationpersistencemodesetting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Bydefault,themodeissetto“autosave,”whichautomaticallysavesconfigurationchangesat
specificintervals.Ifthemodeissetto“manual,”configurationcommandsareneverautomatically
saved.Inordertomakeconfigurationchangespersistentwhenthemodeismanual,thesave
configcommandmustbeissuedasdescribed
in“Configuration PersistenceMode”onpage2‐34.
For information about... Refer to page...
show snmp persistmode 2-35
set snmp persistmode 2-36
save config 2-36
dir 2-37
show file 2-38
show config 2-38
configure 2-39
copy 2-40
delete 2-41
show tftp settings 2-41
set tftp timeout 2-42
clear tftp timeout 2-42
set tftp retry 2-43
clear tftp retry 2-43