Enterasys D-Series - Chapter 6: Port Configuration; Port Configuration Summary; Port String Syntax Used in the CLI

Enterasys D-Series CLI Reference 6-1
6
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Port String Syntax Used in the CLI
Commandsrequiringaport‐stringparameterusethefollowingsyntaxtodesignateporttype,slot
location,andportnumber:
porttype.unit_or_slotnumber.portnumber
Whereporttypecanbe:
fefor100‐MbpsEthernet
gefor1‐GbpsEthernet
tgfor10‐GbpsEthernet
hostforthehostport
vlanforvlaninterfaces
lagfor
IEEE802.3linkaggregationports
Whereunit_or_slotnumberis1fortheD2standaloneunit.
Whereportnumberdependsonthedevice.Thehighestvalidportnumberisdependentonthe
numberofportsinthedeviceandtheporttype.
For information about... Refer to page...
Port Configuration Summary 6-1
Reviewing Port Status 6-3
Disabling / Enabling and Naming Ports 6-7
Setting Speed and Duplex Mode 6-10
Enabling / Disabling Jumbo Frame Support 6-13
Setting Auto-Negotiation and Advertised Ability 6-15
Setting Flow Control 6-19
Setting Port Link Traps and Link Flap Detection 6-21
Configuring Broadcast Suppression 6-30
Port Mirroring 6-33
Link Aggregation Control Protocol (LACP) 6-36
Configuring Protected Ports 6-50