Enterasys D-Series - Chapter 11: Policy Classification Configuration; Policy Classification Configuration Summary; Configuring Policy Profiles

Enterasys D-Series CLI Reference 11-1
11
Policy Classification Configuration
ThischapterdescribesthePolicyClassificationsetofcommandsandhowtousethem.
Policy Classification Configuration Summary
D‐Seriesdevicessupportpolicyprofile‐basedprovisioningofnetworkresourcesbyallowingIT
administratorsto:
•Create,changeorremovepolicyprofilesbasedonbusiness‐specificuseofnetworkservices.
•Permitordenyaccesstospecificservicesbycreatingandassigningclassificationruleswhich
mapuserprofilestoprotocol‐basedframefiltering
policiesconfiguredforaparticularVLAN
orClassofService(CoS).
• Assignorunassignportstopolicyprofilessothatonlyportsactivatedforaprofilewillbe
allowedtotransmitframesaccordingly.
Configuring Policy Profiles
Purpose
Toreview,create,changeandremoveuserprofilesthatrelatetobusiness‐drivenpoliciesfor
managingnetworkresources.
Note: A license is required to enable Policy on the SecureStack B2 and B3 and the D-Series switch.
Refer to “Activating Licensed Features” on page 3-30 for more information.
For information about... Refer to page...
Policy Classification Configuration Summary 11-1
Configuring Policy Profiles 11-1
Configuring Classification Rules 11-6
Assigning Ports to Policy Profiles 11-15
Configuring Policy Class of Service (CoS) 11-17
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy classification on the D-Series devices.