Enterasys D-Series - Downloading from a TFTP Server; Downloading Via the Serial Port

Downloading a Firmware Image
Enterasys D-Series CLI Reference 2-29
Downloading from a TFTP Server
ToperformaTFTPdownload,proceedasfollows:
1. Ifyouhavenotalreadydoneso,settheswitch’sIPaddressusingthesetipaddresscommand
asdetailedin“setipaddress”onpage2‐10.
2. Downloadanewimagefileusingthe copycommandasdetailedin“copy”
onpage2‐40.
Downloading via the Serial Port
Todownloadswitchfirmwareviatheserial(console)port,proceedasfollows:
1. Withtheconsoleportconnected,poweruptheswitch.Thefollowingmessagedisplays:
Version 01.00.29 05-09-2005
Computing MD5 Checksum of operational code...
Select an option. If no selection in 2 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Password: *************
2. Beforethebootupcompletes,type2toselect“StartBootMenu” .Use“administrator”for
thePassword.
Boot Menu Version 01.00.29 05-09-2005
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM (64KB).
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Run Flash Diagnostics
7 - Update Boot Code
8 - Delete operational code
9 - Reset the system
10 - Restore Configuration to factory defaults (delete config files)
11 - Set new Boot Code password
[Boot Menu] 2
3. Type2.Thefollowingbaudrateselectionscreendisplays:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
Note: The “Boot Menu” password “administrator” can be changed using boot menu option 11.