Enterasys D-Series

Configuring Node Aliases
14-34 Logging and Network Management
Configuring Node Aliases
Purpose
Toreview,disable,andre‐enablenode(port)aliasfunctionality,which determineswhatnetwork
protocolsarerunningononeormoreports.
Commands
show nodealias config
Usethiscommandtodisplaynodealiasconfigurationsettingsononeormoreports.
Syntax
show nodealias config [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,nodealiasconfigurationswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaynodealiasconfigurationsettingsforportsfe.2.1through9:
D2(rw)->show nodealias config fe.2.1-9
Port Number Max Entries Used Entries Status
----------- ----------- ------------ ------
fe.2.1 16 0 Enable
fe.2.2 47 0 Enable
fe.2.3 47 2 Enable
fe.2.4 47 0 Enable
fe.2.5 47 0 Enable
fe.2.6 47 2 Enable
fe.2.7 47 0 Enable
fe.2.8 47 0 Enable
fe.2.9 4000 1 Enable
Table 14‐38providesanexplanationofthecommandoutput.
For information about... Refer to page...
show nodealias config 14-34
set nodealias 14-35
clear nodealias config 14-35
port‐string (Optional)Displaysnodealiasconfigurationsetting sforspecificport(s).