EasyManua.ls Logo

Enterasys D-Series

Enterasys D-Series
540 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
show lldp port trap
5-16 Discovery Protocol Configuration
Example
ThisexampleshowshowtodisplayLLDPportstatusinformationforallports.
D2(ro)->show lldp port status
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
show lldp port trap
UsethiscommandtodisplaytheportsthatareenabledtosendanLLDPnotificationwhena
remotesystemchangehasbeendetectedoranLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensed.PortsareenabledtosendLLDPnotificationswiththesetlldpporttrap
command
andtosendLLDP‐MEDnotificationswiththesetlldpportmed‐trapcommand.
Syntax
show lldp port trap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPporttrapinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLLDPporttrapinformationforallports.
D2(ro)->show lldp port trap
Trap-Enabled Ports :
MED Trap-Enabled Ports:
show lldp port tx-tlv
UsethiscommandtodisplayinformationaboutwhichoptionalTLVshavebeenconfiguredtobe
transmittedonports.PortsareconfiguredtosendoptionalTLVswiththesetlldpporttx‐tlv
command.
Syntax
showlldpporttx‐tlv[port‐string]
port‐string (Optional)Displaystheportorrangeofportsthathavebeenenabled
tosendLLDPand/orLLDP‐MEDnotifications.

Table of Contents

Related product manuals