Enterasys D-Series - Chapter 3: Activating Licensed Features; Clearing, Showing, and Moving Licenses

Enterasys D-Series CLI Reference 3-1
3
Activating Licensed Features
InordertoenabletheD2advancedfeatures,suchasPolicy,youmustpurchasealicense.Ifyou
havepurchasedalicense,youcanproceedtoactivateyourlicenseasdescribedinthissection.If
youwishtoobtainapermanentorevaluationlicense,contacttheEnterasysNetworksSales
Department.
Clearing, Showing, and Moving Licenses
Licensescanbedisplayed,applied,andclearedonlywiththelicens e commandsdescribedinthis
chapter.Generalconfigurationcommandssuchasshowconfigorclearconfigdonotapplyto
licenses.
Onceenabled,alllicensesarepermanentnon‐expiring.
Commands
set license
UsethiscommandtoactivatetheD‐Serieslicensedfeatures.
Syntax
set license feature
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
set license 3-1
show license 3-2
clear license 3-2
feature Thenameofthefeaturebeingli censed.