Enterasys D-Series - Chapter 2: Basic Configuration; Quick Start Setup Commands

Enterasys D-Series CLI Reference 2-1
2
Basic Configuration
Atstartup,theD‐Seriesswitchisconfiguredwithmanydefaultsandstandardfeatures.This
chapterdescribeshowtocustomizebasicsystemsettingstoadapttoyourworkenvironment.
Quick Start Setup Commands
ThetablesinthissectionprovideaquickreferencefortheCLIcommandsneededtobeginbasic
D2switchoperation.Table 2‐1liststasksandtheirassociatedCLIcommandsrequiredforsetting
uptheswitchwiththe latestfirmware.Table 2‐2listsoptionalCLIcommandsthatwillhelpyou
performadditional
basicconfigurationontheswitch.Refertothepageslistedformore
informationabouteachcommand.
For information about... Refer to page...
Quick Start Setup Commands 2-1
Setting User Accounts and Passwords 2-2
Setting Basic Switch Properties 2-9
Downloading a Firmware Image 2-28
Reviewing and Selecting a Boot Firmware Image 2-31
Starting and Configuring Telnet 2-32
Managing Switch Configuration and Files 2-34
Clearing and Closing the CLI 2-44
Resetting the Switch 2-45
Using and Configuring WebView 2-47
Table 2-1 Required CLI Setup Commands
Step Task CLI commands
Refer to
page...
1 Set a new password. set password [username] 2-5
2 Set the switch IP address. set ip address ip-address [mask
ip-mask] [gateway ip-gateway]
2-10
3 Download, activate, and verify new
firmware on the switch using TFTP
copy.
copy tftp://tftp_server_ip_address/
filename system:image
2-40
set boot system filename 2-32
show version 2-22