Enterasys D-Series

set dhcp pool default-router
16-22 DHCP Server Configuration
Mode
Switchcommand,read‐write.
Example
Thisexamplerestoresthedefaultleasedurationofonedayforaddresspool“auto1.”
D2(rw)->clear dhcp pool auto1 lease
set dhcp pool default-router
UsethiscommandtospecifyadefaultrouterlistfortheDHCPclientsservedbytheaddresspool
beingconfigured.Upto8defaultrouterscanbeconfigured.
Syntax
set dhcp pool poolname default-router address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleassignsadefaultrouterat10.10.10.1totheaddresspoolnamed“auto1.”
D2(rw)->set dhcp pool auto1 default-router 10.10.10.1
clear dhcp pool default-router
Usethiscommandtodeletethedefaultroutersconfiguredforthisaddresspool.
Syntax
clear dhcp pool poolname default-router
Parameters
Defaults
None.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofadefaultrouter.
address2...address8 (Optional)Specifies,inorderofpreference,upto7additionaldefault
routeraddresses.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.