Enterasys D-Series

clear spantree lpcapablepartner
8-46 Spanning Tree Configuration
Defaults
Ifnoport‐stringisspecified,LoopProtectcapabilityforlinkpartnersisdisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheLoopProtectpartnercapabilityforfe.1.1:
D2(rw)->show spantree lpcapablepartner port fe.1.1
Link partner of port fe.1.1 is not LoopProtect-capable
clear spantree lpcapablepartner
UsethiscommandtoresettheLoopProtectcapabilityofportlinkpartnerstothedefaultstateof
false.
Syntax
clear spantree lpcapablepartner port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheLoopProtectpartnercapabilityforfe.1.1:
D2(rw)->clear spantree lpcapablepartner fe.1.1
set spantree lpthreshold
UsethiscommandtosettheLoopProtecteventthreshold.
Syntax
set spantree lpthreshold value
Parameters
port‐string Specifiesport(s)forwhichtocleartheirlinkpartners’LoopProtect
capability(resettofalse).
value Specifiesthenumberofeventsthatmustoccurduringtheevent
windowinordertolockaport/SID.Thedefaultvalueis3events.A
thresholdof0specifiesthatportswillneverbelocked.