Enterasys D-Series - Clear Spantree Lplock

clear spantree lplock
8-44 Spanning Tree Configuration
Parameters
Defaults
Ifnoport‐stringisspecified,statusisdisplayedforallports.
IfnoSIDisspecified,SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLoopProtectlockstatusonfe.1.1:
D2(rw)->show spantree lplock port fe.1.1
The LoopProtect lock status for port fe.1.1 , SID 0 is UNLOCKED
clear spantree lplock
Usethiscommandtomanuallyunlockablockedportandoptionally,perSID.Thedefaultstateis
unlocked.
Syntax
clear spantree lplock port-string [sid sid]
Parameters
Defaults
IfnoSIDisspecified,SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoclearLoopProtectlockfromfe.1.1:
D2(rw)->show spantree lplock port fe.1.1
The LoopProtect lock status for port
fe.1.1 , SID 0 is LOCKED
D2(rw)->clear spantree lplock fe.1.1
D2(rw)->show spantree lplock port
fe.1.1
The LoopProtect lock status for port
fe.1.1 , SID 0 is UNLOCKED
port‐string (Optional)Specifiesport(s)forwhichtodisplaytheLoopProtectlock
status.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtodisplay
theLoopProtectlockstatus.Validvaluesare0‐4094.Ifnotspecified,
SID0isassumed.
port‐string Specifiesport(s)forwhichtocleartheLoopProtectlock.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtoclearthe
LoopProtectlock.Validvaluesare0‐4094.Ifnotspecified,SID0is
assumed.