Enterasys D-Series

set dhcp pool bootfile
Enterasys D-Series CLI Reference 16-19
set dhcp pool bootfile
UsethiscommandtospecifyadefaultbootimagefortheDHCPclientswhowillbeservedbythe
addresspoolbeingconfigured.
Syntax
set dhcp pool poolname bootfile filename
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthebootimagefilenameforaddresspoolnamed“auto1.”
D2(rw)->set dhcp pool auto1 bootfile image1.img
clear dhcp pool bootfile
Usethiscommandtoremoveadefaultbootimagefromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname bootfile
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthebootimagefilenamefromaddresspoolnamed“auto1.”
D2(rw)->clear dhcp pool auto1 bootfile
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
filename Specifiesthebootimagefilename.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.